Primo test della piastra Eurotek su Quasar Arm…va sicuramente perfezionata…ma siamo già a buon punto
Successivamente la piastra Eurotek 8” con la giusta scelta dei condensatori è passata da i 3.9Khz iniziali a 7.894Khz! Benissimo… seguiranno test sul campo di questa coil, solitamente la parte più complicata nel taglio delle frequenze, non è tanto far “digerire” la piastra al Quasar, ma riuscire a fasare la ferrite!
Thanks a lot! subscribe to my youtube channel and stay tuned here😃
Hello, can you show schematic of connection from eurotek coil to Quasar and values of capacitors ? Greets
try whit different capacitors, then send me feedback or review
try this:
pin 5 RED TX + 220 or 330nF in series (not polarized)
pin 4 BLACK TX-
pin 3 GROUND
pin 2 WHITE RX – parallel 220 or 330nF whit pin 1 (not polarized)
pin 1 GREEN RX +
good luck!
thanks for your feedback. stay tuned and subscribe to my youtube channel
hello can you communicate the voltage value of the capacitor
16Volt is good value
Bonsoir je possède les valeurs des condensateur pour obtenir différentes fréquence , de 11khz a 16, 666 kHz j’ai modifié une SEF 38 en 16,666 kHz si vous voulez plus de détails contacter moi PS j’ai le Quasar de yourdetector
i’m glad for you.
if you want to create an article for this site, i will happy to publicate